UMI3 press/release commands
Posted: Sun May 26, 2013 2:27 am
Hello,
I am trying to do something fairly simple with the UMI3 (logidy). Press button 1, start recording, release, stop recording. My background: I know very little about Midi, even less about Jack and a lot about Linux.
You can set the UMI3 up to produce a bunch of different Midi commands. By default, the event = Note On, CH=1, V1 = C4 (61) and V2 is 127. Not entirely sure what V2 is, but according to the documentation, when the button is release the same command is send but v2 = 0. (which I believe is the same as note off, right ?).
At am running SL v1.6.18. In the midi setup screen, when I press learn, I see only an event when the button is pressed and it is always comes up as Note (not note on or off).
Any tips ? Does sooperlooper interpret the V2 field ?
Much appreciated
Gertjan
I am trying to do something fairly simple with the UMI3 (logidy). Press button 1, start recording, release, stop recording. My background: I know very little about Midi, even less about Jack and a lot about Linux.
You can set the UMI3 up to produce a bunch of different Midi commands. By default, the event = Note On, CH=1, V1 = C4 (61) and V2 is 127. Not entirely sure what V2 is, but according to the documentation, when the button is release the same command is send but v2 = 0. (which I believe is the same as note off, right ?).
At am running SL v1.6.18. In the midi setup screen, when I press learn, I see only an event when the button is pressed and it is always comes up as Note (not note on or off).
Any tips ? Does sooperlooper interpret the V2 field ?
Much appreciated
Gertjan