how to get /sl/#/forceup to work?
Posted: Fri Apr 08, 2016 1:36 pm
Hello all
I'm having a bit of trouble controlling whether an OSC message starts or stops a command.
Using /sl/0/down record followed by /sl/0/up record works pretty much as expected, but only for loops >= 1.00 secs.
If /sl/0/up is sent sooner than 1.00 secs after the down command, nothing happens & the loop keeps on recording
I assume that /sl/0/forceup record is what I want to use in this case, but it doesn't seem to do anything to release the record press.
How should I go about making sure sending /sl/0/forceup record after /sl/0/down record actually makes the recording stop?
Or any other way to making sure an OSC command "releases" a press instantaneously, regardless of how short the delay is between the press and release commands?
I'm sending OSC messages using Max4Live on OS X 10.10.5 over to SooperLooper AU. v1.7.3
Any suggestions and help welcome,
Thank you
Zef
I'm having a bit of trouble controlling whether an OSC message starts or stops a command.
Using /sl/0/down record followed by /sl/0/up record works pretty much as expected, but only for loops >= 1.00 secs.
If /sl/0/up is sent sooner than 1.00 secs after the down command, nothing happens & the loop keeps on recording
I assume that /sl/0/forceup record is what I want to use in this case, but it doesn't seem to do anything to release the record press.
How should I go about making sure sending /sl/0/forceup record after /sl/0/down record actually makes the recording stop?
Or any other way to making sure an OSC command "releases" a press instantaneously, regardless of how short the delay is between the press and release commands?
I'm sending OSC messages using Max4Live on OS X 10.10.5 over to SooperLooper AU. v1.7.3
Any suggestions and help welcome,
Thank you
Zef