Stereo Loop issue
Posted: Thu Sep 17, 2009 12:53 pm
Hi,
I am having an intermittent issue when I try to utilize SL with 2 channel (stereo)loops.
Here is a description of what I am doing:
---SL is instantiated as an AU in Plogue Bidule or Ableton Live and I am controlling loop functions with MIDI bindings.
---SL is setup with one stereo loop
---Sync is set to loop 1 and Quantize can be set to anything excluding 'off' and the issue occurs
This is what happens:
I record my first pass and the 'Left side" or loop input 1 records/plays back as expected
The 'Right side" or Loop input 2 records/plays the first pass normally then records/plays another loop segment as though the right side of the loop is behaving like a new mono loop that is twice as long as the original loop.
In this psuedo diagram below (---left side---) represents the original loop captured between 2 presses of Record.
---Left side---!---Left side---
---Right side---!---dead air---
I have included an audio example where the Left side is dry guitar and the right side is reverb only of the dry guitar to demonstrate the discreet audio channels.
It seems as though this issue occurs if I have quit and then reopened SooperLooper's engine as an AU plugin.
Any ideas would be very helpful,
thanks,
AL
OSX 10.5.7
2.8 ghz MacPro 6 gigs ram
Metric Halo ULN-2 2d driver Rev. 5.0d74 [1426] MIO Console 5.1.00.136
Live 8.04
Plogue Bidule 0.9691UB
I am having an intermittent issue when I try to utilize SL with 2 channel (stereo)loops.
Here is a description of what I am doing:
---SL is instantiated as an AU in Plogue Bidule or Ableton Live and I am controlling loop functions with MIDI bindings.
---SL is setup with one stereo loop
---Sync is set to loop 1 and Quantize can be set to anything excluding 'off' and the issue occurs
This is what happens:
I record my first pass and the 'Left side" or loop input 1 records/plays back as expected
The 'Right side" or Loop input 2 records/plays the first pass normally then records/plays another loop segment as though the right side of the loop is behaving like a new mono loop that is twice as long as the original loop.
In this psuedo diagram below (---left side---) represents the original loop captured between 2 presses of Record.
---Left side---!---Left side---
---Right side---!---dead air---
I have included an audio example where the Left side is dry guitar and the right side is reverb only of the dry guitar to demonstrate the discreet audio channels.
It seems as though this issue occurs if I have quit and then reopened SooperLooper's engine as an AU plugin.
Any ideas would be very helpful,
thanks,
AL
OSX 10.5.7
2.8 ghz MacPro 6 gigs ram
Metric Halo ULN-2 2d driver Rev. 5.0d74 [1426] MIO Console 5.1.00.136
Live 8.04
Plogue Bidule 0.9691UB