SooperLooper Forum

Hi, Just wanted to post an(other) update. I have found a workaround to this issue. It is embarrassingly simple. To recap: with a session active as described in the original thread (slgui connected to sooperlooper engine), disabling (or otherwise interrupting) my network interface caused slgui to los...

Hi, In an older thread ("Lost connection to Sooperlooper engine"), it was recommended by jesse to try the following: Edit /etc/hosts and take the 'localhost' out of the second line starting with ::1. Or even comment the second line out (insert a # at the front). Just wanted to report that ...

Hi, When I start slgui, I get the following messages: [len@stargazer ~]$ slgui slgui: our URL is osc.udp://stargazer:18871/ Changing our url to be : osc.udp://localhost:18871/ slgui: remote looper is at osc.udp://stargazer:9951/ version=1.7.3 loopcount=1 id=1699999482 but treating the engine URL as ...

Hi, Is there a way that I can configure sooperlooper so that slgui remains connected to the looper engine regardless of ethernet connection status? If I start sooperlooper in one terminal I get: [len@stargazer ~]$ sooperlooper SooperLooper 1.7.3 Copyright 2007 Jesse Chappell OSC server URI (network)...

Hey Joe, I have two expression pedals (I'm also using the Behringer FCB 1010 foot controller). I'm using one expression pedal (B) as a volume pedal, i.e., pedal is mapped to MIDI CC 7 (Volume). I have SL MIDI Bindings (under Preferences) set up so that CC 7 maps to command 'wet' (main out). In my ca...

Note that the workaround I posted earlier only works if 'Loop #' under 'Command/Control' (in Preferences > MIDI Bindings) is set to 'All'. I thought 'Global' should work, since 'quantize' is a global setting, but it doesn't.

Best,
Len

I have been experiencing this issue as well. As a workaround, I have an expression pedal set to CC 16 (General Purpose controller), but it only sends values 0 - 3 (four values) instead of 0 - 127 (128 values). I have Sooperlooper MIDI Bindings set up so that CC 16 maps to the 'quantize' command. The...